Publicidad
Idiomas disponibles
Idiomas disponibles
29 / EN
1.
Connect each cable pair to a breaker (check the electrical layouts). Make sure each
breaker is connected to a black and a red cable. Make sure the heater is connected to
the specific circuit breaker on the main electrical board.
2.
Use an appropriate cable caliber, compatible with the applicable electrical regulations
for the size of breaker. Ensure the correct wiring from the breakers in the main electrical
board to the heater. Connect the power cable to the terminal block inside the heater.
3.
Each entry circuit requires a separate ground connector.
4.
VERIFY that the electrical connections are correct, as well as the adjustment and firmness
of the cable connections. It is important to make sure the correct breaker size and correct
caliber are used, and to make sure the unit has been properly grounded following the
applicable regulations.
5.
The front cover of the heater must be replaced and attached with two screws.
6.
Make sure you have purged all the air out of the water lines before starting the heater.
IMPORTANT: to ensure correct operation of the water heater, make sure that the
connections have been made correctly. It is important that the equipment is connected
as described in this manual. If the wires are mixed up, the water heater will not work
properly even if it turns on and appears to work properly.
Publicidad
