5.1.4 ANTI-SCALP WHEELS
These anti-scalp wheels are designed to minimize
scalping when mowing on rough, uneven terrain. After
setting the cutting height, adjust the anti-scalp wheels
(2) so they extend below the deck but do not contact
the ground. They should always be at least 1/4" to 3/4"
below the deck (1). With the mower sitting on a flat level
surface, the wheel position can be adjusted up or down
as needed from 3/4" to 1-3/4" from the anti-scalp wheels
(2) to the ground.
Move the wheels up or down - using the different axle
mount holes in the wheel mount bracket (if applicable
on model).
1. After adjusting the cutting height, adjust the anti-
scalp wheels by removing the locking flange nut, the
hex bolt which fix the wheels.
2. Select a hole so that the wheel is positioned to the
corresponding height-of-cut desired.
Note: For cutting height over 4.5 inches (114 mm)
use the bottom hole. The anti-scalp wheels will be
effective against scalping.
3. Install the locking flange nut and the hex nut.
4. Repeat the adjustment on the other anti-scalp
wheels.
English
1
2
2
1
1.5-2.5 in
2.5-3.5 in
3.5-4.5 in
5.1.5 FOOT PEDAL & DECK HEIGHT
ADJUSTMENT PIN
Before using the mower, raise the deck height to the
cutting position best suited for your lawn.
When transporting the mower, adjust the deck height to
5.5'' by stepping on the foot pedal to the end and lock.
Cutting height is adjustable from 1.5-4.5 inches. Deck
should be raised to avoid stumps, rocks or other
obstacle that might damage mower deck.
To adjust the cutting height:
1. Stop the mower and disengage blades.
2. Turn the start key to OFF position and set the
parking brake.
3. Step on the foot pedal (2) and push forward till the
very end.
4. Choose a desired deck height, insert the height
adjustment pin (1) into slot to secure.
5. Slowly release the foot pedal.
5.1.6 CONTROL PANEL
2
1
9
8
Note: Adjustments for blade speed, drive speed, and
lights are only possible on the home screen.
1. Blade Speed / Back Button: Adjust the blade speed
(cyclic). / Return to previous page.
17
1
2
3
4
5
6
7
EN