Publicidad
Idiomas disponibles
Idiomas disponibles
EN
10.7 SERVICE THE MOWER BLADES
10.7.1 MOWER BLADE MAINTENANCE
Inspect the mower blades on a daily basis. They are crucial for power efficiency and optimal mowing. Ensure they
are sharp, as a dull blade can cause tearing instead of cutting, resulting in a brown and ragged appearance on the
grass within a few hours. Additionally, a dull blade requires more power. Replace any blades that are bent, cracked,
or broken.
Never attempt to straighten a bent blade by heating, or weld a cracked or broken blade as the blade may break and
cause serious injury. Replace worn or damaged blades.
Never work with blades while the start key is in the ignition switch. Turn the start key to "OFF" position, remove
the batteries from the product. Support the mower with certified jack stands when working beneath it. Wear gloves
when handling blades. Always check for blade damage if mower strikes a rock, branch or other foreign objects!
•
The blade sail (curved part) must be pointing upward toward the inside of the deck to ensure proper cutting.
•
Rotate blades after installation to ensure blade tips don't touch each other or the sides of the mower.
•
Ensure correct torque on the bolt to prevent potential blade loss, which may result in serious injury.
•
Mower blades are sharp and capable of cutting. Always wear gloves and exercise extra caution during servicing.
10.7.2 REMOVE THE MOWER BLADES
Mower blades are sharp. Always wear gloves when handling or working near mower blades.
1. Park the mower on a flat level surface, disengage the PTO and pivot the steering control levers outward to
engage the parking brake. Shut off the mower, remove the start key and batteries.
2. Use a jack stand to lift the front of the mower chassis upward for easier access to the blades. The jack stand can
be put against the front hitch. Ensure the mower is secure before working underneath it.
Make sure the mower is secured when it is lifted by the jack stand and while working on it.
3. Place a block of wood between the blade and the deck to prevent it from spinning while you work.
4. Loosen the blade bolt by rotating counterclockwise with a 24mm socket or wrench.
5. Remove the blade bolt, spacer, blade, and blade support.
English
WARNING
WARNING
WARNING
WARNING
32
Publicidad
