GENWEC FALCON GW01 40 04 00 Manual De Instrucciones página 5

INSTALLATION
Connection to the mains, as well as internal settings such as regulating motor speed,
disconnection of the heating element and the detection range, must be carried out by an
authorised technician.
The following are the steps to be followed for wall installation of the appliance in the two possible
versions (conventional and plug-in).
Conventional or surface version
Requires removal of casing. To do this, the following steps must be followed.
1.
Unscrew the two front screws with the special wrench provided
After this, the device is attached to the wall and power supply following the steps below.
Place the 4 rubber silent blocks provided in the corresponding slots of the plastic base.
1. Make the holes in the wall (8 mm)
according to the template provided.
Remove and clean dust. Insert the
pegs supplied.
Replace the casing and secure it to the base by inserting the two M6 screws into their frontal
positions.
GND
L
N
2. Connect the power and earthing
cables, passing them through
the hole in the base (22 mm) and
connecting them to the power strip
lines, respecting the polarity (N, L,
GND).
2.
Remove the casing by lifting it up
at a slight slant until the two upper
tabs are released.
3.
Secure everything to the wall
by firmly screwing in the screws
supplied.