Publicidad
Idiomas disponibles
Idiomas disponibles
Plug-in version
Enables installation and removal of the entire appliance. In the event of a breakdown, it makes it
possible to easily replace the installed equipment with a new one.
The plug-in base part must previously be attached to the wall and the power cables from the wall
installation must be connected to the power strip that incorporates that part.
1.
Make the holes in the wall (8 mm)
according to the template provided.
Remove and clean dust. Insert the
pegs supplied.
4.
Attach the dryer against this plug-in base.
L
GND
N
2.
Connect the power and earthing
cables, passing them through
the hole in the base (22 mm) and
connecting them to the power strip
lines, respecting the polarity (N, L,
GND) indicated on it. The power
strip should be attached to its
casing on the base using the screws
provided. Then place the electrical
insulating placket, securing it with
the two screws. After screwing on
the placket, the power strip will be
securely attached.
Fit the two plug-in tabs
into the dryer casings
Fit the dryer plug-in tab
into plug-in casing
3.
wall by firmly screwing in the
screws supplied.
5.
Secure both assemblies by inserting the safety screw
supplied.
Secure the plug-in base to the
Publicidad
