Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
3
Setting the code on the
remote control and receiver
NOTE: The frequencies on your receiver and hand unit
have been preset at the factory. Before installing the
receiver, make sure the dip switches on the receiver
and hand unit are set to the same frequency. The dip
switches on the hand unit are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage
the hand unit. Dispose of used battery properly and keep
the battery out of the reach of children.
□ Remove the remote control (J) battery cover by pressing firmly
on the arrow and sliding the cover off.
□ Slide the dip switches (ZZ) to your choice of either up or down.
The factory setting is up.
□ Slide the dip switches (ZZ) on the receiver (I) to the same
position as set on the remote control (J).
□ Install the 23A 12V battery (K).
□ Replace the battery cover on the remote control (J).
□ Insert the silicone rubber stopper (OO) into the hole on the
receiver (I) to cover the dip switches.
I
ZZ
J
OO
4
Making the electrical connections
WARNING: Each wire connecting nut supplied with
this fan is designed to accept up to one 12-gauge
house wire and two wires from the fan. If you have
larger than 12-gauge house wiring or more than one
house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.
IMPORTANT: Use the wire connecting nuts (BB) supplied
with your fan. Secure the connectors with electrical tape
and ensure there are no loose strands or connections.
□
Spread the wires apart so that the green and whites are one
side of the outlet box and the black wire is on the other side.
□
Connect the green fan wires to the household ground wire
(this may be a green or bare wire) using a wire connecting
nut (BB).
□
Connect the receiver (I) red or black wire to the household
black (hot) wire using a wire connecting nut (BB).
□
Connect the receiver (I) white wire to the household white
(neutral) wire using a wire connecting nut (BB).
□
Secure each wire connecting nut using electrical tape.
□
Wire the receiver (I) to the fan wires by connecting the
molded adaptor plug from receiver (I) with molded adaptor of
the fan motor assembly (C) together.
Black
White
I
Black
8
Outlet box
in the ceiling
Green or bare wire
White
BB
C
Publicidad
