16
INSTALLATION
9
Insert the water supply tube at least 5/8 in.
(15 mm) into the connector.
1 0 Hook the tab on the door switch side
of the cover under the edge of the wire
opening in the cabinet top.
11
Position the cover into place. Insert and
tighten the cover screw.
--@
NOTE
1) Gently press the Coltet and insert the
tube until only one line shows on the
tube.
(Correct)
(Incorrect)
2) Pull the tube to make sure that the
tube is tightly fastened and then insert
the clip.
Removing
the Freezer Drawers
The top, middle and bottom drawers are all
removed in the same way. tn the following
figures, the Pullout Drawer located above the
freezer drawer is not shown for clarity.
.... Z_
CAUTION
• Use two or more people to remove and
install the freezer drawer. Failure to do so
can result in back or other injury.
Do not hold the handle when removing
or replacing the drawer. The handle may
come off and it could cause personal
injury.
• Be careful of sharp hinges on both sides
of the drawer.
• When you lay the drawer down, be
careful not to damage the floor.
Do not sit or stand on the freezer drawer.
• To prevent accidents, keep children and
pets away from the drawer. Do not leave
the drawer open.
1
Pull the drawer open to full extension.
Remove the lower basket
by lifting basket
from rail system.
2
assembly.
Press in the tabs on the rail covers and
lift them up to separate from the rail