Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the cordless heat gun and check that
here are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting/replacing the battery
■ Press the charged battery into the power
tool until it clicks into place (see figure B).
■ To remove, press the release button(1.)
and pull out the battery(2.) (see figure C).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short
circuit the contacts; explosion and fire hazard!
Strap fixing (see figure D)
WARNING!
Let the heat gun cool completely before
attaching a wrist stap. The hot nozzle can
cause damage.
■ Strap fixing 8 is provided to attach a wrist
strap (not included) in order to reduce the
chances of dropping your tool. Wrap the
strip around your hand when carrying the
tool.
Installing/removing a nozzle
attachment (see figure E)
WARNING!
Make sure the nozzle always points away
from you and any bystanders.
■ To install, slide the nozzle attachment onto
the heat gun nozzle (1) and twist it into
place.
■ To remove, allow tool to cool to room
temperature, then twist and pull the nozzle
attachment away from tool.
12
Switching on the power tool (see
figure F)
■ To switch the power tool on:
– Push the lock-off lever upwards (1.) and
press the trigger switch (2.). Press the lock-
on button (3.) for continuous operation.
■ To switch the power tool off:
– Release the trigger switch (6).
– To stop the tool from the continuous
position, press the switch trigger (6) again
NOTE
Let the tool cool down before moving or
storing it.
LED light (see figure G)
■ The LED worklight (7) lights up when the
heat gun is turned on.
■ Release trigger switch, the LED worklight
(7) goes out automatically.
Power setting (see figure H)
■ Slide the power setting (2) backward for
high heat or forward for low heat.
■ The heat gun is capable of producing
temperatures in excess of approximately
260°C on the low setting and 530°C on the
.
high setting
Using the Heat Gun
WARNING!
To reduce the risk of injury, do not remove
or attach nozzle attachment until tool has
cooled to room temperature.
NOTE
Do not position the nozzle too close to the
workpiece that you are using the power
tool on. The resulting air blockage can lead
to the heat gun overheating.
The distance between the nozzle and the
workpiece depends on the material you
are working on (metal, plastic etc.) and the
intended working method.
The optimum temperature for each
application can be determined by a practical
test.
Always test the amount of air and temperature
first. Start at a greater distance and a lower
power setting. Then adjust the distance and
power setting according to requirements.
If you are unsure what material you are
working on or what effect the hot air might
have on it, first test the effect on a concealed
area.
HG 530 18
.
Publicidad
