Publicidad
Idiomas disponibles
Idiomas disponibles
HG 530 18
You can work without accessories for all
examples of work. However, using the
recommended accessories will simplify the
work and considerably increase the quality of
the result.
Removing varnish/loosening
adhesives
Fit the flat nozzle attachment (9). Briefly soften
the varnish with hot air and remove it with a
clean spatula. Long heat exposure burns the
varnish and makes removal more difficult.
Many adhesives can be softened using
heat. By heating adhesives, you can break
connections or remove excess adhesive.
Soft Soldering
Fit the reduction nozzle attachment (10).
If you are using solder without flux, apply
soldering grease or paste to the solder joint.
Heat the solder joint and apply the solder. The
solder must be melted by the temperature of
the workpiece.
If necessary, remove the flux after the solder
joint has cooled down.
Heat-shrinking
Fit the reflector nozzle attachment (11).
Choose the diameter of the heat shrink plastic
tube suitable for the workpiece. Evenly heat
the heat shrink plastic tube until it fits closely
against the workpiece.
Maintenance and care
WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior and
motor with dry compressed air.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
The instruction can also be available on
www.flex-tools.com.
Disposal information
WARNING!
Render redundant power tools unusable:
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal
options!
13
Publicidad
