Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION PROCESS
Ultrasonic
cleaning
Ultrasonic cleaning is to use the penetrating and cavitation shock
waves generated when ultrasonic waves propagate in the medium,
and powerfully clean objects with complex shapes, cavities and
pores to completely remove stubborn carbon deposits on the fuel
injector.
Preparation
●
Remove the fuel injector from the vehicle and check whether
its rubber seal is damaged. If it is damaged, it should be
replaced in time before the cleaning test to avoid leakage
during the test. Then put the fuel injection nozzle into the
cleaning agent, carefully remove the external grease and wipe
it with a soft cloth.
●
Turn on the power and turn on the power switch on the side of
the main unit.
●
Put the cleaning bracket in the accessories into the ultrasonic
cleaning tank, and place the wiped fuel injector in the cleaning
bracket positioning hole of the ultrasonic tank.
Methods And Steps
●
Add an appropriate amount of cleaning agent to the ultrasonic
tank and spread the cleaning agent over the bottom of the
cleaning stand.
●
Insert the plugs of the drive wires into the injector sockets in
turn. (Special fuel injectors need to be connected with an
adapter cable)
●
Press the item selection up and down keys to select the "01
Ultrasonic Cleaning" item, and then press the working time up
and down keys to set the time. (The system defaults to 10
minutes, if you need to modify the time, you can use the up and
down keys to change)
●
Press the start button and turn on the ultrasonic cleaning
switch on the side of the device to start cleaning. When
working, you can press the pause button to suspend work or
press the stop button to exit.
●
During the cleaning process, the heating switch on the side of
7
Publicidad
