Publicidad
Idiomas disponibles
Idiomas disponibles
Injector
diagnostic
the equipment can be turned on to improve the cleaning effect.
●
The working time gradually decreases. When it is 0, the system
automatically stops.
●
Take out the fuel injection nozzle from the ultrasonic tank, wipe
the cleaning liquid on it with a soft cloth, and prepare for the
next job.
NOTE
During the cleaning process, you can hear the intermittent
(approximately 5 seconds) vibrating sound when you take the
fuel injector out and put it to your ear, so you can judge whether
the fuel injector is working normally.
Ultrasonic cleaning is strictly prohibited when there is no
cleaning agent in the ultrasonic tank to avoid equipment
damage.
Only the ultrasonic cleaning agent dedicated to cleaning the
fuel injection nozzle can be added to the ultrasonic tank, and
other reagents cannot be used instead, otherwise any
malfunctions and damages caused will not be covered by the
warranty.
This function is to detect the atomization, dripping, blockage, fuel
injection angle status of the fuel injectors and the size and
balance of the fuel injection of each fuel injector at different
speeds.
Preparation
●
Confirm that the oil drain handle is open, use the funnel in the
accessories to add the test liquid to the equipment through the
glass window, and pay attention to control the flow rate during
the addition to avoid overflow.
●
Add 1 bottle (about 1000ml) of testing agent each time.
●
Install the fuel injector.
8
Publicidad
