Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Guide
Always use two people when setting up the base.
Place the bed base box in a desired location
1
with the bottom of the box facing up. Remove
the binding straps and packing materials,
making sure not to puncture the box with any
sharp objects.
Remove the bed base from the box. Unfold the
2
bed making sure to keep the bottom of the bed
facing up.
Note: To install headboard brackets (sold
separately), see instructions on
To install the legs, thread the leg into frame, and
3
tighten by hand. Do not over tighten. Note: Legs
are shipped fully assembled. Alternative heights
can be achieved by removing leg segments.
Locate the battery backup strap and install (2) 9V
4
Alkaline batteries (not included). Store the strap
in a convenient location in case of an emergency
power outage. For operating instructions see
page 18.
Uncoil the input power cord (connected to
5
control box's power port) and plug into the
power supply.
6
page
17.
7
8
9
10
- 10 -
View Setup Video
Uncoil the power cord and connect to the power
supply. Place power supply on the ground and
extend from the base. Ensure that the power
supply and all attached cords are directed
toward the desired surge protector.
Carefully flip the base over on to its legs.
Important: Two people are required to move the
bed base. Do not drag across the floor. Do not
rest frame on its side, excessive pressure may
damage the legs.
Plug the power cord into a power source. A
surge protector is recommended.
Ensure batteries are correctly installed in the
back of the remote. Test remote control functions
to verify proper setup before placing mattress
on base. Return the base to a flat position before
placing the mattress on top.
Insert the ends of the mattress retainer bar into the
holes at the foot of the platform.
Setup is now complete!
Publicidad
