Keysight U1731C Guia Del Usuario página 32

1 Introduction
Table 1-5 Keypad functions (continued)
Function when pressed for:
Legend
Less than 1 second
Switches between the dissipation factor (D),
DQO
quality factor (Q), or phase angle (θ)
Limit
measurement.
Selects a test frequency.
Freq.
– Press
Freq.
DCR
test frequencies (100 Hz to 100 kHz).
Disables autoranging and sets a manual range.
Range
– Press
Range
Auto
Auto
available measurement range.
Switches between impedance (Z), inductance (L),
ZLCR
capacitance (C), and resistance (R) measurement.
P S
32
again to cycle through the various
again to cycle through each
More than 1 second
Enables or disables the limit comparison mode.
– While the annunciator is flashing,
– press and again to toggle between
DQO Range
Limit Auto
high (H) or low (L) limits, then
– use the and
Freq.
low limit set (1 to 16).
– Press to start the limit sorting (with the
Hold
Rec
selected limit set), or
– If no activity is detected after 3 seconds, the
limit comparison will begin.
– Press for more than 1 second to exit this
DQO
Limit
mode.
U1733C only: Enables or disables the DCR
(direct current resistance) mode.
– Press for more than 1 second to exit this
Freq.
mode. The LCR meter will return to inductance
measurement by default.
Enables autoranging.
Toggles between parallel and series circuit mode.
Keysight U1731C/U1732C/U1733C User's Guide
Learn more
on:
keys to select a high/
page 53
and
page 58
page 53
page 23
page 43
page 51
and
page 53
to