Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones página 20

English
9. Compound cutting procedures
Compound cutting can be performed by following the instructions in 7 and 8 above. For maximum dimensions
for compound cutting, refer to "SPECIFICATIONS" table on page 8.
CAUTION:
10. Crown molding cutting procedures
Fig. 33 shows two common crown molding types having angles of (θ) 38° and 45°.
For the typical crown molding fi ttings, see Fig. 34.
Wall
The table below shows the miter angle and the bevel angle settings that are ideal for the two crown molding
types.
NOTE:
For convenience, positive stops are provided for the miter setting (left and right 31.6°)
positions.
For miter cut setting
If the turntable has been set to either of the angles described, move the turntable adjusting side handle a little
to the right and left to stabilize the position and to properly align the miter angle scale and the tip of the indicator
before the operation starts.
For bevel cut setting
Move handle on bevel section to the left and check that the position is stable and that the bevel angle scale
and the tip of the indicator are properly aligned. Then tighten the clamp lever.
Type of
Crown
Molding
45° Type
38° Type
30° and 33.9° left slant setting method
Holder (A)
Set pin
Indicator
(For bevel scale)
Bevel Scale
Fig. 35
20
Always secure the workpiece with the right or left hand and cut it by sliding the
round portion of the saw backwards with the left hand.
It is very dangerous to rotate the turntable to the left during compound cutting
because the saw blade may come into contact with the hand that is securing the
workpiece.
In case of compound cutting (angle + bevel) by left bevel, turn the sub-fence
counterclockwise, and engage in the cutting operation.
Ⓐ upper surface
Ceiling
Ⓑ lower surface
Fig. 33
To process crown molding at
positions 1 and 4 in Fig. 34.
Miter Angle Bevel Angle
Setting Setting
right 35.3° left 30°
( mark) ( mark)
right 31.6° left 33.9°
( mark) ( mark)
(1) Loosen the clamp lever and slant to the left a little at a time while
(2) With the set pin in the slot as described above, setting to the 30°
Clamp
lever (3) Also, with the set pin in the slot as described above, setting to
(4) Look at the bevel scale and indicator to recheck whether or not
Tighten
Push
Loosen
Ceiling
Wall
1 2
Inside corner
Fig. 34
To process crown molding at
positions 2 and 3 in Fig. 34.
Miter Angle Bevel Angle
Setting Setting
left 35.3° left 30°
( mark) ( mark)
left 31.6° left 33.9°
( mark) ( mark)
pushing the set pin into the main unit. At this time, the fi xing pin
will enter one step and fi t into the 30° left slant and 33.9° left slant
setting slots.
left slant position is possible by pushing to the right side.
the 33.9° left slant position is possible by pushing to the left side.
the settings match and then tighten the clamp lever.
3 4
Outside corner