Cutting Operation - Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones

2. Using the Vise Assembly (Standard accessory)
Screw holder
6mm wing
bolt (B)
Fence
Vise shaft
6mm wing bolt (A)
Fig. 24
WARNING:
Always fi rmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
CAUTION:
Always confi rm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the
6 mm wing bolt (B) and move the vise assembly to a position where it will not
contact the saw blade.

3. Cutting Operation

ⓐ
ⓐ ⓑ
Marking Marking
ⓐ ⓑ
(pre-marked) (pre-marked)
(Front View)
Fig. 25
CAUTION:
* Increased pressure on the handle will not increase the cutting speed.
On the contrary, too much pressure may result in overload of the motor and/or
decreased cutting effi ciency.
WARNING:
* Confi rm that the trigger switch is turned OFF and the power plug has been
removed from the receptacle whenever the tool is not in use.
* Always turn the power off and let the saw blade stop completely before raising
the handle from the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing fragments to scatter about
dangerously.
* Every time one cutting or deep-cutting operation is fi nished, turn the switch off ,
and check that the saw blade has stopped. Then raise the handle, and return it to
the full retract position.
* Be absolutely sure to remove the cut material from the top of the turntable, and
then proceed to the next step.
* Continued cutting operation can result in overload of the motor. Touch the motor
and if it's hot, stop your cutting operation once and rest for 10 minutes or so, and
then restart your cutting operation.
(1) The vise assembly can be mounted on either the left fence {Fence
Knob (B)} or the right fence {Fence (A)} by loosening the 6mm wing bolt (A).
(2) The screw holder can be raised or lowered according to the height
Vise plate
of the workpiece by loosening the 6mm wing bolt (B). After the
adjustment, fi rmly tighten the 6mm wing bolt (B) and fi x the screw
holder.
(3) Turn the upper knob and securely fi x the workpiece in position
(Fig. 24).
Workpiece
Adjusting Line
ⓑ
(1) As shown in Fig. 25 the width of the saw blade is the
width of the cut. Therefore, slide the workpiece to the
right (viewed from the operator's position) when length
ⓑ is desired, or to the left when length ⓐ is desired.
(Only Model C8FSHE
If a laser marker is used, align the laser line with the left
side of the saw blade, and then align the ink line with the
laser line.
(2) Once the saw blade reaches maximum speed, push the
handle down carefully until the saw blade approaches
the workpiece.
(3) Once the saw blade contacts the workpiece, push the
handle down gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth, turn the
power tool OFF and let the saw blade stop completely
before raising the handle from the workpiece to return it
to the full retract position.
C8FSHE(S))
•
English
17