Speed Priorities (Non-External Control); Operating The Pump While Running - Pentair VS2 Guia De Instalacion

12
schedule.
Note: If the pump has been stopped via the Start/Stop
button, the pump will not run until the pump is turned
back on by the Start/Stop button. If the Start/Stop LED is
illuminated then the pump is on and will run the programmed
schedule.
Note: If a user wants to have a period of time during the day
when the pump is not running, any of the SPEEDs can be
programmed to 0 RPM. This will cause the pump to remain
stationary/paused throughout the duration of that SPEED.

Speed Priorities (Non-External Control)

For schedule duration settings, SPEEDs are prioritized as follows:
SPEED 1 -> SPEED 2 -> SPEED 3. SPEED 1 is the highest priority,
while SPEED 3 is the lowest.
The drive will not allow a user to program a schedule of more
than 24 hours. When the 24th hour of duration is programmed
it will take time from the lower priority speeds in order to add
them to the SPEED currently being adjusted.
Starting Schedule (Before Adjustment)
SPEED 1 duration = 20 hours
SPEED 2 duration = 2 hours
SPEED 3 duration = 2 hours
If the user reprograms SPEED 1 to run for 23 hours, SPEED
2 (lower priority speed) will automatically adjust to a 1 hour
duration and SPEED 3 (lowest priority speed) will adjust to
a 0 hour duration.
End Schedule (After Adjustment)
SPEED 1 duration = 23 hours
SPEED 2 duration = 1 hour
SPEED 3 duration = 0 hours

Operating the Pump While Running

If power is connected to the pump motor, pressing any of the
following buttons referred to in this section could result in the motor
starting. Failure to recognize this could result in personal injury or
damage to equipment.
Pressing the Display button will cycle through the current
parameters.
• Speed — current run speed
• Time — current time of day
• Duration — amount of time remaining at
Example:
the current run speed
• Watts — amount of watts currently
being consumed
Pressing any of the Speed Buttons ("1", "2", "3", "Quick Clean")
while the pump is running will act as temporary override. It
will run the speed and duration that is programmed for that
button. Once completed it will default back to the appropriate
point in the programmed schedule.
Note: If you adjust the speeds of the schedule while the
pump is running, it will run the adjusted speed for the rest
of the current duration, but will not save the adjustments.
Exception: Speed and Duration adjustments to QUICK CLEAN
will always be immediately saved.
Quick Clean
If running Quick Clean, pressing the "+" or "-" arrows will
change the speed accordingly. Pressing the Quick Clean button
again within 10 seconds of pressing the "+" or "-" arrows will
allow you to adjust the duration of Quick Clean via the "+" and
"-" arrows. These changes will be saved immediately and are
the new defaults for Quick clean. Pressing the Quick Clean
button again will cycle through the two Quick Clean settings.
The pump will exit out of editing mode if no additional buttons
are pressed within 10 seconds.
If Quick Clean is running and you wish to stop the Quick Clean
prior to the duration being completed you can press and hold
the Quick Clean button for 3 seconds and the pump will return
to the appropriate point in the programmed schedule.
Some speeds might cause resonance and noise
coming from the pump in specific installations.
This can be solved by slightly modifying the speed.