ENGLISH
2.
Edge mode: the display will show MODE 1 and the robot will clean along the edges.
3.
Area mode: the display will show MODE 2 and the robot will clean a 2*2 m area.
4.
Random mode: the display will show MODE 3 and will start cleaning in a random way.
5.
DeepCleaning mode: the display will show MODE 4 and the robot will clean over the same
spot 2 times for a deeper cleaning.
6.
Scrubbing mode
Press the
button to enter the water-intensity mode and select the desired intensity and
select between 1, 2 or 3 (see WATER INTENSITY/TIME SETTINGS section).
•
Do not use the mop outdoors.
•
Remove the carpets before operating the robot under this mode.
•
During operation, control the water level on the water tank. If it empties, fill it up
again before continuing scrubbing.
•
Take the water tank and the mop out before charging the robot.
Note: in order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
7.
Schedule cleaning
•
The robot can be programmed to operate automatically
at the desired time.
8.
Magnetic restricted area
•
Use the magnetic stripe provided to delimit a certain
zone, to which the robot will not be able to access and clean.
•
For example, place the magnetic stripe from one door's frame to the other in order
to forbid the robot from crossing to a room.
5. CLEANING AND MAINTENANCE
CLEANING SIDE BRUSHES
•
Make sure the side brushes are in good conditions.
•
If the bristles are deformed, introduce the side brush into water.
•
Clean them regularly in order to keep them in good conditions.
CLEANING WATER, DUST TANK AND FILTERS
•
Empty and clean the dust tank after each use.
•
Wash the filters each 15-30 days to lengthen their service life.
•
Dry completely the filters before placing them back in their position.
•
Do not expose the filters to direct sunlight.
•
The maximum service life of the primary and EPA filter is 6 months.
28