Publicidad
Idiomas disponibles
Idiomas disponibles
SPLIT 1X1
AROMA 2E
ATTENTION
AFTER CONFIRMING THE ABOVE CONDITIONS, FOLLOW THESE GUIDELINES WHEN
WIRING:
• Always have an individual power circuit specifically for the air conditioning equipment. Always
follow the circuit diagram placed inside the cover of control.
• The screws securing the wiring to the electrical connection housing may become loose du-
ring transport. Since loose screws can cause cable burns, check that the screws are securely
tightened.
• Check the power supply specifications.
• Confirm that the electrical capacity is sufficient.
• Confirm that the starting voltage is maintained at more than 90% of the nominal voltage mar-
ked on the nameplate.
• Confirm that the cable thickness is as indicated in the power source specifications.
feeding.
• Always install a grounded circuit breaker in damp or wet areas.
• The following can be caused by a drop in voltage: vibration of a mag switchnetic, damage to
the contact point, broken fuses and alteration of normal operation.
• Disconnection of the power supply must be incorporated into the fixed wiring. The with
Contacts must have a minimum separation of at least 3 mm on each active conductor.
(phase)
• Before accessing the terminals, all supply circuits must be disconnected.
NOTE: To comply with mandatory EMC regulations, required by international standard CISPR 14-1:2005/
A2:2011 in specific countries or districts, be sure to apply the correct magnetic rings on your equipment
according to the wiring diagram of his team.
Please contact your dealer or installer for more information and to purchase magnetic rings (the su-
pplier's magnetic ring is TDK (model ZCAT3035-1330 or similar).
INSTALLATION MANUAL
7. WIRING
61
Publicidad
