Publicidad
Idiomas disponibles
Idiomas disponibles
Care ¸and ¢Jeaning
Light Bulb Replacernent
Unplug
refrigerator
before
changing
a
light
bulb.
Before
replacing
a burned-out
light
bulb,
unplug
the refrigerator
or turn off power
at the circuit
breaker
or' fuse box in order* to avoid contact
with a live wire
filament.
(A burned-out
light bulb may break when
being replaced.)
Note:
Moving
the control
to the
OFF
position
does not remove
power to the light
circuit.
Fresh Food Compartment---Upper
Light
I. Pull off temperature
control knobs.
Pin
2. Pull the bottom
of the light shield
down
and
forward,
then rotate
the top up and off.
After replacing with same size bulb, reinstall light
shield.
Fresh
Food Compartment_Lower
Light
(on some models)
This light is located
behind
the top drawer or right
above
the top drawer
(depending
on your model)°
J. Unplug
the _efrigeratoro
2,
3_
,
.
If the light is behind
the top drawer' you will need
to remove
the drawer
and the shelf above it,. To
remove the drawer
see To Remove
Storage
Drawers
in the Shelves and Storage
Drawers
section.
To remove
the shelf, first
remove any food on the
shelf. Then
tilt the shelf up
at the fiont
and lift it up
and out of the traclcs,
Grasp the bottom of
the light shield and pull it
forward and up,,
After replacing
with same size bulb, replace
the
shield.
If you cannot
locate
the correct
bulb, see
your dealer_
tf the light was behind
the top drawer, you will need
to replace the drawer
and the shelf above it.
To replace the shelfl raise the shelffront
slightly and
engage the top hooks in the lowest large track slots,
Tl-ien lower the front of the shelf until it is level_
6. Plug the refrigerator
back in.
Freezer
Compartment
IJ
Remove shelf just below
light panel. (Shelf will be
easie_ to remove if ir is
emptied first.)
2_
Pull plastic light panel
towazd you, (It will bend
to flee tabs f_om grooves0
3. After' replacing with same
size bulb, reinstall panel and shelf,
22
Publicidad
