Publicidad
Idiomas disponibles
Idiomas disponibles
• The light plate is supplied separately
and has a magnetic attachment. To
install it, attach it to the LED light
bracket so that it is magnetised and
proceed with the electrical connections.
Connect the two wires coming from the
motor to the two wires coming from the
LED light plate.
• Lastly, put the lamp cover. Carefully
insert the lamp shade into the LED light
holder and slide it down, it will snap
into position by its own weight. When
inserting the light cover be careful not
to bend it too much or it could break.
Fig. 13.B
• On your model, the LED light bracket
is already attached to the fan from the
factory. Therefore, you must begin the
procedure by attaching the LED light
plate.
• The light plate is supplied separately
and has a magnetic attachment. To
install it, attach it to the LED light
bracket so that it is magnetised and
proceed with the electrical connections.
Connect the two wires coming from the
motor to the two wires coming from the
LED light plate.
• Lastly, put the lamp cover. The cover
will be threaded to the light support.
Make the threads match the slight
creases on the support and turn it
clockwise until well fixed. Make sure it
is well fixed.
Note: You can also mount the light support
and/or the LED light plate before ceiling
installation of the fan.
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
In case the product shows any imbalance
or vibration, you can use the balancing kit
included to adjust it.
Remote control connection:
See picture 06 on page 9.
L : AC IN 220-240V
N : AC IN 220-240V
Blade balance kit:
Included in the purchased product you will
find a kit supplied to prevent the blades
from moving unbalanced.
The fan may wobble during functioning
due to an irregularity in the blades or
blade support. Also, improper installation
or an inclined angle can cause additional
problems.
It is recommended to follow the next
procedure to solve any of these problems :
• Make sure that all blades are screwed
firmly into their mounts and are tight to
the fan body.
• Looking at the fan from below, check
and make sure that no blade holder is
bent so all the blades are in the correct
position.
• Using a ruler you can check the blade
route. Simply place the ruler against the
roof vertically, and note the distance
from the edge of the blade to the roof.
Carefully spin the blades with your
hand to check all the blades. If the
blades are not aligned, the holder can
be slightly bent up or down to align it
with the rest of the blades.
If after following all these steps the problem
is not solved, a small adjustment must be
made using the balance kid provided.
• Turn the fan on and change the speed
until the most noticeable swing occurs
(usually the highest speed).
• Turn off the fan. Select a blade and
place the balancing clip on the edge of
it, between the holder and the tip.
• Turn the fan back on and see if the tilt
has improved or worsened. Turn the fan
off and change the clip to another blade
to check again. Repeat this process for
all blades and note which blade has the
most noticeable improvement.
EN
35
Publicidad
