Descargar Imprimir esta página

universalblue UVT1376-24 Manual De Instrucciones página 36

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
• Put the clip back on the blade where
you noticed the greatest improvement.
Move the clip along the blade and turn
on the fan to find the position where the
clip offers the better improvement.
• Next, remove the clip and place one of
the balance weights on the point where
the clip was placed. To do so separate
the white sticker with your fingernails
or, if necessary, carefully use a knife or
scissors.
• Make sure the problem has been solved.
If the imbalance persists, repeat the
process. You can use light weights on
those blades that may need it.
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 4 hours.
Remote control:
See picture 09 on page 11.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
14. Button
SUMMER mode function.
15. Button ALL OFF: Press this button to
turn off the fan and light.
16. Button
: Press this button to turn
on and off the light. If you want to
change the light colour, press it until
the wanted colour is set.
17. Button
: Press this button to set
NATURAL mode function.
18. Button
: Press this button to set
the WINTER mode function.
19. Button
: press it to turn off the
36
: Press this button to set
fan.
20. Buttons 1 to 6: Press any of these
buttons to set the fan speed, being 1
the lowest speed and 6 the highest
21. Button 4H: Setting for the fan to turn
off automatically after four hours of
operation.
22. Button 2H: Setting for the fan to turn
off automatically after two hours of
operation.
23. Button 1H: Setting for the fan to turn
off automatically after one hour of
operation.
In order to be able to use the ceiling fan
through the remote control, the receptor
included with this device must be installed
before, as explained in the installation
section of this manual.
To use the remote control, you must add 2
batteries to the bottom of the remote.
If your model has LED light with different
colour tones, you can change the colour
temperature of the light by switching it on
and off with the wall switch, the remote
control or, in case of a smart fan, from your
terminal. See picture 07 on page 9.
Each
associated with the receiver
included with the fan.
When you turn off the fan with
the remote controller, the light
settings will be saved according
to the last option you selected.
For example, if the light is set to
the "warm" position when you turn off the
fan, when you turn on the fan again with
the remote controller the light will be set to
"warm" again. However if you turn on/off
the fan with the wall switch the settings
will not be saved and the light will turn on
according to the default settings (some
models do save the settings when using
the wall switch)
First use:
• Switch it on.
remote
control
is

Publicidad

loading

Este manual también es adecuado para:

Uvt1377-24Uvt1378-24Uvt1379-24Uvt1380-24