Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING
TRIMMER
ATTACH-
MENT (OR OTHER OPTIONAL
AT-
TACHMENTS)
CAUTION:
When removing or instal-
ling attachments,
place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Upper Shaft
Coupler
.OOSEN
Attachment
TIGHTEN
Knob
2.
Press and hold the locking/release
button.
Locking/Release
Button
erator's manual. Using the wrong hole
could lead to serious injury or damage
to the unit.
Secondary
Hole
Locking/Release
Button in Primary
Hole
OPERATING
INSTRUCTIONS
To maximize
operating
efficiency,
do
not run the engine for longer than 1
minute at a time at full throttle.
OPERATING
POSITION
ALWAYS USE:
Hearing
Protection
Eye Protection
C°uF
Upper Shaft
Attachment
3. While securely holding the engine
and upper shaft, pull the attach-
ment straight out of the coupler.
INSTALLING
OPTIONAL
ATTACH-
MENTS
1. Remove the shaft cap from tile at-
tachment
(if present).
2.
Position locking/release
button of
attachment
into guide recess of
coupler.
3.
Push the attachment
into the cou-
pler until the locking/release
button
snaps into the primary hole.
4.
Before using the unit, tighten the
knob securely
by turning clock-
wise.
Coupler
Primary Hole
Guide Recess
Upper
Locking/
Attachment
Shaft
Release
Button
_WARNING:
Make sure the lock-
ing/release
button is locked in the pri-
mary hole and the knob is securely
tightened
before operating
the unit. All
attachments
are designed to be used in
the primary hole unless otherwise
stated in the applicable attachment op-
Long
Pants
Heavy
Shoes
Cut from your left to your right.
dllWARNING:
Always wear eye
protection and hearing protection. Never
lean over the trimmer head. Rocks or
debris can ricochet or be thrown into
eyes and face and cause blindness or
other serious injury.
When operating
unit, stand as shown
and check for the following:
• Wear eye protection,
hearing protec-
tion and heavy clothing.
• Hold trigger handle with right hand
and assist handle with left hand.
• Hold unit so that engine is below
waist level.
• Cut only from your left to your right to
ensure debris is thrown away from
you. Without bending over, keep line
near and parallel to the ground and
not crowded into material being cut.
Do not run the engine at a higher speed
than necessary. The cutting line will cut
efficiently when the engine is run at less
than full throttle. At lower speeds, there
is less engine noise and vibration.
12
Publicidad
