Publicidad
Idiomas disponibles
Idiomas disponibles
The recommended installation height of the CALIFORNIA is 1.8m - 2.4m (71"-95") from the floor. The lower
the heater is positioned, the more intense the heat.
Under no circumstances is the unit to be installed at less than 1.8m (71") from the floor. Consideration
should be given to any temporary or occasional additions such as stages or platforms and adjusted
accordingly. For outdoor use, or other areas with air movement/wind the directional Infrared spread may
reduce by 1/3 to 1/2. In all locations, ensure hot parts are not touched accidentally.
Wall mounting swivel brackets are provided with the heater which has been specifically designed to allow
this product to be fitted to a wall with adequate clearances at the back of the unit. Do not mount the heater
with any other bracket except those provided.
The sides and ends of the heater must always be at least 300mm (12") away from the nearest wall, ceiling
or other structure.
INSTALLATION:
Diagram 1: Bracket Assembly
Diagram 2: Wall Mounting Position
Using the brackets as a template, mark and drill 4 x 8mm holes in the wall. Insert the plugs into the wall
and fit the brackets, washers, spring washers and nuts over the exposed threaded ends. Tightening the
nuts will force the plug end to expand in the wall and form a secure mounting for the heater.
Fit the opposite bracket to the back of the heater before then inserting and tightening the bolt and nut
for each hinge.
Diagram 3: Installation using a stand:
Mounting Hardware Includes:
•
4 x bracket pieces - fit together to form 2
brackets with a central pivot. The protruding blade on
each bracket fits over the circular end of the opposing
bracket to ensure the correct pivot angle.
4 x M6x60 masonry expansion bolts (for fitting
•
brackets onto wall).
•
2 x small bolts to fit brackets onto the rear of the
heater.
•
2 x small bolts and lock nuts (to form the pivot
on the brackets).
ENGLISH
Publicidad
