Important; Direction Of The Air Flow - AERMEC FCW 222V Manual De Uso E Instalación

IMPORTANT

Note for FCW series with microprocessor controller:
- The two control types, wired control panel (PFW2) and remote control (TLW2), can be used at the same time on the same fan
coil unit.
– If the fan coil is off, all the previous settings made are kept in the memory except for the TIMER setting and SLEEP mode.
– If the fan coil is turned on using the (ON/OFF) key, the TIMER setting and SLEEP mode are cancelled.

DIRECTION OF THE AIR FLOW

The blades on the air discharge are arranged to direct the air in
two directions:
– vertical blades, to be adjusted manually
– motorised horizontal blades for versions with microprocessor
controller, to be adjusted only by means of the TLW2 remote
control or the PFW2 wired control panel
– horizontal blades for versions without microprocessor control-
ler to be adjusted manually.
ADJUSTING THE VERTICAL BLADES
– turn the vertical blades as indicated in the diagram
– both in heating or cooling mode it is advisable for the air flow
not to hit people directly.
MOTORISED HORIZONTAL BLADES
Never adjust the motorised horizontal blades manually. Any
manual operation on the blades may damage the system and
cause a malfunction.
When the unit is off the blades close and cover the air flow outlet.
IMPORTANT
Under particular external conditions condensate might occur on
the surface of the blades (during cooling and dehumidification)
and drip onto the surfaces below.
The direction of air flow as shown in the
TLW2
PFW2
LOUVER
TLW2
diagram
PFW2
33