Publicidad
Idiomas disponibles
Idiomas disponibles
EN
NOTE Operation of 12 V devices is not possible as soon as the battery pack is in low battery status (state
of charge < 5 %).
The DC output provides a mobile power supply with up to 150 W continuous power.
1.
Place the battery pack on a firm and heat-resistant base.
2. Open the device lid to access the connections and controls.
3. Connect the power cable of the 12 V device to the DC output of the battery pack.
The 12 V device is automatically supplied with power for operation via the battery pack. The battery status indica-
tor shows the remaining state of charge of the battery pack.
4. After use, diconnect the power cable of the 12 V device and close the device lid of the battery pack.
8 Cleaning and maintenance
WARNING! Electrocution hazard
Unplug the device from the power supply before each cleaning and maintenance.
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents, or bleach during cleaning as these can
damage the device.
Occasionally clean the device with a so, damp cloth.
Regularly check live cables or lines for insulation faults, breaks, or loose connections.
9 Storing
NOTICE! Damage hazard
• Only store the battery pack fully charged. Recharge the stored battery pack regularly and at least
every 3 – 6 months, even when not in use.
• Observe the specified optimum storage temperature as long-term storage at high and low tempera-
tures can impair the service life and performance of the battery pack.
Store the battery pack in a well-ventilated, dry place where it is protected from dust and dirt.
Regularly check the state of charge of the battery pack (see chapter
page 8).
10 Troubleshooting
Problem
The battery pack does not work. The
button does not respond.
10
Possible cause
The battery pack is deeply discharged.
Checking the state of charge
Suggested remedy
Charge the battery pack (see chap-
ter
Charging the battery pack
page 8).
on
on
Publicidad
