Publicidad
Idiomas disponibles
Idiomas disponibles
LED 1
Using the LED flashlight
CAUTION! Risk of injury
Avoid looking directly into the LED flashlight as this may damage your eyes.
NOTE The flashlight is adjustable in 2 color temperatures: Neutral white (at 4300 K) and cool white (at
6400 K).
1.
Open the device lid to access the connections and controls.
2. Press and hold the
The battery status indicator is lit.
3. Press the
button to switch between the color temperatures.
NOTE If loads or charging sources are connected, the cool white color temperature is not available
and the flashlight is set to neutral white automatically.
4. Hold the flashlight by the carrying handle. The carrying handle can be adjusted to the required length.
5. After use, close the device lid.
Charging digital devices via USB
The USB-C output has a charging power of 60 W, the USB-A output has a charging power of 18 W.
NOTE
• Charging of digital mobile devices is not possible if the battery pack is in low battery status (state of
charge < 5 %).
• Two digital mobile devices can be charged at the same time by using both USB outputs.
1.
Open the device lid to access the connections and controls.
2. Select a charging cable with a suitable adapter depending on the USB output to be used, and connect the bat-
tery pack to the digital device.
The digital device is automatically charged via the battery pack. The battery status indicator shows the remaining
state of charge of the battery pack.
3. After charging, remove all charging cables and close the device lid.
Operating 12 V devices
NOTICE! Damage hazard
Provide sufficient ventilation and ensure that the heat generated can be dissipated from the battery pack.
Battery status indicator
LED 2
LED 3
button for 3 s to turn the flashlight on or off.
LED 4
LED 5
EN
Battery capacity
61 ... 80 %
81 ... 100 %
9
Publicidad
