EN
3 Safety instructions
General safety
WARNING! Electrocution hazard
• Do not operate the device if it is visibly damaged.
• The device may only be repaired by qualified personnel. Improper repairs can lead to considerable
hazards.
• Do not disassemble the device.
• Do not modify or adapt any of the components in any way.
• Only use accessories and spare parts that are recommended by the manufacturer.
• Do not use the device in wet conditions or submerge in any liquid. Store in a dry place.
• Switch off the device and disconnect it from the power supply before each cleaning or maintenance
and after every use.
WARNING! Risk of injury
Batteries contain aggressive and caustic acids. Avoid battery fluid coming into contact with your body. If
your skin does come into contact with battery fluid, wash that part of your body thoroughly with water. If
you sustain any injuries from acids, contact a doctor immediately.
WARNING! Health hazard
• Do not open or damage batteries or allow them to enter the environment, as they contain toxic and
environmentally harmful heavy metals.
• This device is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the device by a person responsible for their safety.
• Electrical devices are not toys. Always keep and use the device out of the reach of very young
children.
• Children must be supervised to ensure that they do not play with the device.
• Cleaning and user maintenance shall not be made by children without supervision.
NOTICE! Damage hazard
• Before start-up, check that the voltage specification on the data plate is the same as that of the pow-
er supply.
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Ensure that the negative and positive poles never come into contact.
• Do not use the cables as a handle.
Operating the device safely
CAUTION! Explosion hazard
• Do not operate the device under the following conditions:
4
In salty, wet or damp environments
In the vicinity of corrosive fumes
In the vicinity of combustible materials
In areas where there is a risk of gas or dust explosion