Tectro TP 3020 Instrucciones De Uso página 62

Design Notice
In order to ensure the optimal performance of our products, the design specifica-
tions of the unit and remote control are subject to change without prior notice.
Energy Rating Information
The Energy Rating for this unit is based on an installation using an un-extended
exhaust duct without window slider adaptor (as shown in the Installation section
of this manual). At the same time, the unit must be operate on the COOL MODE
and HIGH FAN SPEED by remote controller.
Ambient Temperature Range For Unit Operating
Exhaust hose installation
The exhaust hose and adaptor must be installed or removed in accordance with
the usage mode. For COOL,HEAT (heat pump type) or AUTO mode must be instal-
led exhaust hose. For FAN, DRY or HEAT (electrical heat type) mode must be
removed exhaust hose.
Choosing The Right Location
Your installation location should meet the following
requirements:
-
-
-
-
Recommend Installation
4
62
MODE Temperature Range
Cool 17-35°C (62-95°F)
Dry 13-35°C (55-95°F)
Make sure that you install your unit on an even surface to
minimize noise and vibration.
The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit) must be
accessible.
The unit should be located at least 30cm (12") from the nearest
wall to ensure proper air conditioning. The horizontal louver
blade should be at least 50cm (19.7") away from obstacles.
DO NOT cover the Intakes, Outlets or Remote Signal Receptor
of the unit, as this could cause damage to the unit.