Tectro TP 3020 Instrucciones De Uso página 63

1. Exhaust hose
2. Exhaust hose assembly
3. Unit Adaptor
4. Wall exhaust adaptor A
Type wall installation
Energy Rating Information
The energy rating and noise information for this unit is based on the standard
installation using an un-extended exhaust duct without window slider adaptor (as
shown in the Installation section of this manual). At the same time, the unit must
be operate on the COOL MODE and HIGH FAN SPEED by remote controller.
The unit with 3 meters extended exhaust duct is running by using 2 exhaust ducts
(Diameter:150mm, Length:1.5m + Diameter: 130mm, Length: 1.5m) .The Energy
rating and noise information for unit with 3 meters extended exhaust duct is not
assessed.(For some models)
G
NOTE:
We recommend that operating the unit at room temperature below
35°C . Since there is a risk that the unit with 3 meters extended exhaust
duct would not work at room temperature above 35°C under some
extreme conditions, such as the lower air intake be blocked for 50%.
Tools Needed
- Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors;
- Saw (optional, to shorten window adaptor for narrow windows)
Shape Name of
Accessories
Unit Adaptor
Exhaust Hose
Exhaust Hose
Adaptor
NOTE: Items with (*) are on some models. Slight variations in design may occur.
Window Installation Kit
Step One: Preparing the Exhaust Hose assembly
Press the exhaust hose(or extended exhaust hose) into the window
slider adaptor(or wall exhaust adaptor) and unit adaptor, clamp
automatically by elastic buckles of the adaptors.
Step Two: Install the Exhaust hose assembly to the unit
Push the Exhaust hose into the airoutlet opening of the unit along
the arrow direction.
Qty Shape
1 pc
Bracket and 2
1 pc
1 pc
(*)
Name of Qty
Accessories
Security 1 set
screws
Drain Hose 1 pc
4
63