Tectro TP 3020 Instrucciones De Uso página 67

This is to protect the unit. Operation will automatically start after 3 minutes.
POWER MANAGEMENT FEATURE
Under cooling operation, when the ambient temperature is lower than the setting
temperature for a period of time, the unit will be automatically operate power
management feature. The compressor and fan motor stop. When the ambient
temperature is higher than the setting temperature, the unit will be automatically
quit the power management feature. The compressor and (or) fan motor run.
WATER DRAINAGE
- During dehumidifying modes, remove the drain plug from the back of the unit,
install the drain connector (5/8" universal female mender) with 3/4" hose (locally
purchased). For the models without drain connector, just attach the drain hose
to the hole. Place the open end of the hose directly over the drain area in your
basement floor.
1. Remove the drain plug
2. Continuous drain hose
NOTE: Make sure the hose is secure so there are no leaks. Direct the hose toward
the drain, making sure that there are no kinks that will stop the warter flowing.
Place the end of the hose into the drain and make sure the end of the hose is
down to let the water flow smoothly. When the continuous drain hose is not used,
ensure that the drain plug and knob are installed firmly to prevent leakage.
- During heating pump mode, remove the lower drain plug from the back of
the unit, install the drain connector(5/8" universal female mender) with 3/4"
hose(locally purchased). Carefully move the unit to a drain location, and let
the water drain away.
NOTE: Make sure the drain hose is lower than the bottom tray drain outlet.
1. Remove the drain plug
2. Continuous drain hose
4
67