Publicidad
Idiomas disponibles
Idiomas disponibles
2. Plug the smaller end of the USB cable
EN
port
9
3. Plug the larger end of the USB cable into the USB port of the
USB wall adapter
adapter matches the voltage of the power outlet.
4. Plug the USB wall adapter into a power outlet for charging.
Charging starts automatically. Check the program indicator
lights
6
One indicator light = 25 % charged
Two indicator lights = 50 % charged
Three indicator lights = 75 % charged
Four indicator lights = fully charged
5. When charging is done, unplug the USB wall adapter from the
power outlet and disconnect the USB cable from the charging
port of the remote control.
8 Assembly
Follow the illustrations to assemble the elastic straps (see Fig. C).
1. Open the hook-and-loop fasteners on the elastic straps
and guide the elastic straps through the side openings of the
neck mask
2. Close the hook-and-loop fasteners to secure the elastic straps
on the neck mask.
9 Sensitization test
Before carrying out your first treatment you must carry out a
sensitization test. Follow the steps below:
1. Place the product over your inner arm.
2. Switch ON the product and allow the product to run for its
full 10-minute treatment program.
3. At any time if your skin feels hot or uncomfortable, stop using
the product immediately.
4. After the treatment, wait at least 6 hours. If the skin on your
inner arm appears red and/or itchy, then the product is not
suitable for you. Return the product to the retailer within
14 days of purchase.
17
of the remote control (see step 2 in Fig. B).
. Make sure the voltage marked on the
13
for the charging progress:
.
1
into the charging
4
3
Publicidad
