Qilive Q.6341 Manual De Instrucciones página 20

EN
Attention:
The installation of the pipes and electrical equipments should be done by
professionals.
6.1. ABOUT POWER CONNECTION
WARNING:
For personal safety:
■ Do not use an extension cord or an adapter plug with this appliance.
■ Do not, under any circumstances, cut or remove the earthing connection from
the power cord.
Electrical requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the
appropriate power supply. Use the required fuse 10A/13A/16A, time delay fuse or circuit breaker
recommended and provide separate circuit serving only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being corresponds to those on the rating plate.
Only insert the plug into an electrical socket which is earthed properly. If the electrical socket to
which the appliance must be connected is not appropriate for the plug, replace the socket, rather
than using a adaptors or the like as they could cause overheating and burns.
Ensure that proper earthing exists before use
6.2. WATER SUPPLY AND DRAIN
Cold water connection
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear. This precaution is needed to avoid the risk
of the water inlet to be blocked and damage the appliance.
About the safety supply hose
The safety supply hose consists of the double walls. The system guarantees its intervention by
blocking the flow of water in case of the supply hose breaking and when the air space between
the supply hose itself and the outer corrugated hose is full of water.
Warning:
A hose that attaches to tap can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected
and the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses out from storage compartment located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn the water fully on before starting the dishwasher.
ordinary supply hose
20
safety supply hose