Publicidad
Idiomas disponibles
Idiomas disponibles
4. INSTALLATION
EN
Precautions before installation:
–
Before installation or adjustment of accessories, ensure that the refrigerator is disconnected
from power.
4.1. LOCATION
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm,
and the room is well ventilated. Avoid locating your Fridge/Freezer near a heat source, eg, cooker,
boiler or radiator. Also avoid direct sunlight in outbuildings or sun lounges. If you are placing your
Fridge/Freezer in an outbuilding such as a garage or annexe, ensure that the Fridge/Freezer is
placed above the damp course, otherwise condensation will occur on the Fridge/Freezer cabinet.
Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free
space should be spared at the top side, more than 100mm on both sides, and above 50mm at the
back side of the refrigerator.
Fig. 1
4.2. LEVELLING FEET
If the Fridge is not level, the door and magnetic seal
alignment will be affected and may cause you Fridge
to work incorrectly. Once the Fridge is placed in its final
location, adjust the leveling feet at the front by turning
them.
4.3. MOVING THE APPLIANCE
1.
Remove all food from inside the appliance.
2.
Pull the power plug out, insert and fix it into the power plug hook at the rear or on top of the
appliance.
3.
Tape parts such as shelves to prevent from falling off while moving the appliance.
4.
Move the appliance with more than two people carefully. When transporting the appliance
over a long distance, keep the appliance upright.
Precautions before operation:
–
Before making changes, the refrigerator must be disconnected from power.
–
Precautions should be taken to prevent any personal injury.
W
D
H
A
B
C(°)
E
Fig. 2
F
12
470
447
496
800
874
130±5
50
100
(Dimensions in mm)
Publicidad
