Publicidad
■
Do not use soap, detergent, scrub power, spray cleaner, etc., as these may cause
EN
odors in the interior of the refrigerator or contaminated food.
■
Clean the bottle frame, shelves and drawers with a soft cloth dampened with
soapy water or diluted detergent. Dry with a soft cloth or dry naturally.
■
Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy
water, diluted detergent, etc., and then wipe dry.
■
Do not use hard brushes, clean steel balls, wire brushes, abrasives (such as
toothpastes), organic solvents (such as alcohol, acetone, banana oil, etc.), boiling
water, acid or alkaline items, which may damage the cooler surface and interior.
Boiling water and organic solvents such as benzene may deform or damage
plastic parts.
■
Do not rinse directly with water or other liquids during cleaning to avoid short
circuits or affect electrical insulation after immersion.
6.2. DEFROST
■
Unplug the power cord.
■
Remove the foods from the refrigerator and place them properly to prevent foods
from going bad, then prepare a water container for holding defrosting water.
■
It is recommended to use a dry towel to dry the defrosting water on liner and
evaporator, then wring dry the towel. Repeat the operation until defrosting
completed.
■
You can defrost the appliance naturally under room temperature, you can also use
the ice shovel to eliminate the frost (use plastic or wooden ice shovel to prevent
damage to the liner).
■
You can also use the appropriate amount of hot water to speed up defrosting, with
the dry towel to dry the water after defrosting.
■
Put all foods back and power on the appliance again.
6.3. STOP USING
■
Power failure: In case of power failure, even if it is in summer, foods inside the
appliance can be kept for several hours; during the power failure, the times of
door opening shall be reduced, and no more fresh food shall be put into the
appliance.
■
Long-time nonuse: The appliance shall be unplugged and then cleaned; then the
doors are left open to prevent odor.
■
Moving: Before moving the refrigerator, take out all objects inside, fix the glass
partitions, vegetable holder, freezing chamber drawers and etc. with tape, and
tighten the levelling feet; close the doors and fix them with tape. During moving,
the appliance shall not be laid upside down or horizontally, or be vibrated; the
inclination during movement shall be no more than 45°. Do not hold the door and
hinge when moving this unit.
The appliance shall run continuously once it is started. Generally, the operation of
the appliance shall not be interrupted, otherwise the service life may be impaired.
6.4. CHANGE THE LAMP (OPTIONAL)
Any replacement or maintenance of the LED lamps is intended to be made by the
manufacturer, its service agent or similar qualified person.
Replacement of incandescent lamps:
Disconnect the power supply before carrying out the bulb replacement.
1.
Hold and remove the light bulb cover.
2.
Dismantle the old bulb by unscrewing it counter-clockwise.
3.
Replace by a new bulb (max. 15W) by screwing it clockwise, and make sure it is
4.
fixed in the bulb holder tightly.
Reassemble the light cover and re-connect your Fridge to the power supply.
5.
14
Publicidad
