GE AVM4160 Instrucciones De Instalación página 18

Installation Instructions
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABI NET TEMPLATE.
Ar, AI ITl_l
Jl_P_U|I U|_I: Wear safety goggles when
drilling holes in the cabinet bottom.
| ADJUST BLOWER MOTOR
[] Remove the screws holding the blower unit and
the screws securing the blower plate. Remove
the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up.
Blower Motor Screws
I
Blower Plate
Blower
"_"- Motor
Screw
I_] Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
r_ ADJUST BLOWER MOTOR (cont.)
O
: ...s _-" Back of
._ i f.%_-z
--.-_._s _" Mlrcrowave
13] Roll the blower so that fan blade openings are
facing the top of the oven. Place the blower back
into the opening.
Fan Blades
Wire<_ 7 _I
Note: Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to
the fan motor wiring, insert motor carefully such that
the fan motor wiring does not contact the microwave
power cord bracket.
WARNING: .isk ofElectric Shock.
Can cause injury or death. Do not pull or stretch the
blower unit wiring. Hake sure the wires are not
pinched.
[_]Slide the blower plate back onto the microwave
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear slot.
Replace 3 screws.
I
Tab
Side Slot
Rear Slot
18