Cameo AZOR B1 Manual De Usuario página 11

Dimmer Curve =
Pan reverse =
Tilt Reverse =
P/T Feedback =
PWM Frequency =
Fan =
Move Blackout =
Auto Test =
Reset =
Adjust =
Factory Reset =
DEVICE INFORMATION (System Info)
Press MODE to access the selection menu. Using the UP and DOWN controls, select the menu item "System Info" (observe arrow) and
confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info

This will take you to the sub-menu for displaying device information. Use the UP and DOWN keys to select the desired parameter and then
retrieve and/or configure with ENTER.
dimmer curve Linear
Exponential
Logarithmic
S-Curve
Pan reverse Yes
No
Tilt reverse Yes
No
Correction of head Yes
position
No
LED PWM frequency 800 Hz
1200 Hz
2000 Hz
3600 Hz
Adjusts fan speed Auto
Low Noise
Automatic blackout during No
head movement
Yes
Automatic Auto-Test now?
function test
Restart the device Reset now?
Correct the Pan Offset
zero position
Tilt Offset
Colour Offset
Gobo Offset
6Pri Offset
R6Pri Offset
8Pri Offset
R8Pri Offset
Focus Offset
reset to factory settings Reset now?
Light intensity increases linearly with DMX
value
Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher
DMX values
Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values
Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted at
medium DMX values
reverses pan direction
do reverse of pan direction
reverses tilt direction
does not reverse tilt direction
Automatic position correction is enabled
Automatic position correction is disabled
Configuration of LED PWM frequency
Automatic fan speed control
Extra quiet fan with reduced brightness
No blackout during head movement
Blackout during head movement
Press ENTER for step-by-step function test of
the LED and all motors (Pan, Tilt, Gobo...)
Press MENU to stop the function test
Restart the device with reset of all motors
0-255 Correct pan zero position
0-255 Correct tilt zero position
0-255 Correct colour wheel zero position
0-255 Correct gobo wheel zero position
0-255 Correct linear prism zero position
0-255 Correct linear prism rotation zero position
0-255 Correct circular prism zero position
0-255 Correct circular prism rotation zero position
0-255 Correct focus zero position
Press ENTER to implement reset
Press MENU to cancel reset
11