Tabla de contenido
Publicidad
PLEASE NOTE
• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: "Welcome to Cameo",
the model and the software version. After this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX modes or slave mode is enabled and there is no control signal at the DMX input, the characters in the display will start
to flash. The flashing stops when a control signal is present.
• After approx. 30 seconds of inactivity, the current operating mode is automatically displayed.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to previ-
ously selected menu items and sub-menu items. 1. Press MENU and ENTER simultaneously for direct access to the last-edited sub-menu
item, where you can make changes instantly as required (DMX starting address and all modes). 2. Press MENU for direct access to the
last-selected and last-edited menu item. Press ENTER repeatedly to access the sub-menu items in order to change individual settings (DMX
starting address and all modes).
• The display can be rotated through 180° by pressing UP when the main display is visible. If the display is rotated by 180°, the functions of
UP and DOWN are reversed and DOWN must be pressed to rotate the display again.
OPERATION
MAIN DISPLAY
After the start-up process is complete, the spotlight is ready for operation and starts in the previously selected mode. The current mode is
displayed (in the example, DMX mode with DMX address).
SETTING DMX START ADDRESS (DMX ADDRESS)
Press MENU to access the selection menu. Using the UP and DOWN controls, select the menu item "DMX address" (observe arrow) and
confirm with ENTER. The display will show a three-digit number field and you can use the UP and DOWN controls to configure the desired
DMX start address (highest value is dependent upon the active DMX mode). Confirm the entry with ENTER and press MENU to return to the
main display (in the example, "DMX address 001").
----------------- Menu ----------------
DMX Address
DMX mode
Stand Alone
Slave
Settings
System Info
CONFIGURING DMX MODE (DMX Mode)
Press MENU to access the selection menu. Using the UP and DOWN controls, select the menu item "DMX Mode" (observe arrow) and con-
firm with ENTER. In the submenu you can now select from the DMX modes "13CH" and "16CH" with UP and DOWN. Confirm your selection
with ENTER. Tables with the channel assignments can be found in these instructions under DMX CONTROL.
----------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
6
DMX Address
001
Current operating mode
001
–
DMX Address
5xx
001
------------ DMX Mode ------------
13CH
16CH
Publicidad
Tabla de contenido
