Publicidad
Idiomas disponibles
Idiomas disponibles
'11. Final Installation
Checklist
• Check to make sure the circuit breaker is closed
(RESET) or the circuit fuses are replaced.
• Be sure power is in service to the building..
, Check to be sure that all packing materials and tape
have been removed, This will include tape on metal
panel under control knobs (if applicable), adhesive tape,
wire ties, cardboard and protective plastic.. Failure to
remove these materials could result in damage to the
appliance once the appliance has been turned on and
surfaces have heated,
• Check to make sure that the rear leveling leg is fully
inserted into the Anti-Tip bracket and that the bracket is
securely installed.
12. Operation
Checklist
Turn on one of the surface units to observe that the
element glows within 60 seconds. Turn the unit off when
glow is detected, tf the glow is not detected within the
time limit, recheck the range wiring connections. If
change is required, retest again.. If no change is
required, have building wiring checked for proper
connections and voltage_
Check to make sure the Clock (on models so equipped)
display is energized, If a series of horizontal red lines
appear in the display, disconnect power immediately..
Recheck the range wiring connections_ If change is
made to connections, retest again. If no change is
required, have building wiring checked for proper
connections and voltage. It is recommended that the
clock be changed if the red lines appear..
. Be sure all range controls are in the OFF position before
leaving the range..
Problem
Possible
Causes
Surface units
The surface units are not plugged
not functioning
in solidly.
properly
The surface unit controls
are improperly
set,
The drip pans are not set securely
in the cook-top.
Oven light does
Light bulb is loose or defective,
not work
Switch operating
light is broken.
Oven will not work
Plug on range is not completely
inserted in the electrical outlet.
A fuse in your home may be blown
or the circuit breaker tripped.
Oven controls improperly set.
Food does not bake
Oven controls improperly set.
or roast properly
Shelf position is incorrect or the
shelf is not level.
Incorrect cookware or cookware of
improper size being used.
Oven thermostat needs adjustment.
What To Do
With the controls off, check to make sure the surface
unit is plugged completely into the receptacle.
Check to see the correct control is set for the surface
unit you are using.
With the controls off, check to make sure the drip .pan is
in the recess in the cooktop and that the opening _nthe
pan lines up with the receptacle.
Tighten or replace the bulb_
Cal! for service.
Make sure electrical plug is plugged into a live, properly
grounded outlet..
Replace fuse or reset circuit breaker.
See the Using the oven section_
See the Using the oven section,.
See the Using the oven section,.
See the Using the oven section.
See the Adjust the oven thermostatuEasy
to do
yourself!
section_,
22
Publicidad
