Druck DPI104 Instrucciones De Seguridad Y Guía Del Usuario página 9

2. The display initially shows the full-scale rating of the
instrument.
3. After a short delay, the pressure measurement is
displayed.
Power Off Sequence
Refer to Figure B2 and the procedure below.
1. Display showing pressure measurement.
2. Press and hold the
3. The display shows
4. Press the button to turn off.
Change the Pressure Units
Refer to Figure C1 and the procedure below.
1. Display showing pressure measurement in mbar
pressure units.
2. Press and hold the
3. The display shows
4. Press the button again.
5. The display shows
6. Press the button to cycle through the available
pressure units.
7. Example shows psi pressure units flashing.
8. Press the button to accept psi pressure units.
9. Display showing pressure measurement in psi
pressure units.
Set Tare (or Set Zero)
Refer to Figure D1 and the procedure below.
1. Display showing pressure measurement of 70 mbar.
2. Press and hold the
zero reading.
3. The display shows
4. Display showing pressure measurement with a tare
value of 70 mbar.
button.
(off).
button.
(off).
(units).
button to tare the instrument to a
(done).
Copyright 2018 Baker Hughes Company.
English–DPI104 / DPI104-IS Safety Instructions | 3