Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
5. Attaching the Door Catch
• Locate the Top Panel (G) and place on a flat
surface.
• Attach the Magnetic Door Catches (CC) to the Top
Panel (G) using Screws (DD) where indicated by
the diagram.
Note: Do not tighten the screws in this step. After
assembling the door in step 29, adjust the
magnets position forward or backward to
better match the door to the unit, and then
tighten the screws.
Hardware Used
Magnetic Catch
CC
Ø3x15mm
DD
Screw
6. Constructing the Side Partitions
• Attach Left Upper Side Panel (H) to Left Upper
Front Panel (F), inserting the pre-installed
hardware on the edges of Left Upper Side Panel
(H) into the pre-drilled holes on Left Upper Front
Panel (F).
• Repeat these steps to attach the Right Upper
Side Panel (K) to Right Upper Front Panel (J).
7. Attaching the Gas Springs
• Attach the Gas Springs (EE) to the Left Upper
Partition (I) and the Right Upper Partition (L),
using screws (FF).
Hardware Used
Gas Spring
EE
Ø3.5x12mm
FF
Screw
28WM373 REV2.0
x 2
x 4
x 2
x 6
11
5
6
H
F
7
I
G
K
J
L
Publicidad
