Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
40. Installing the Tip Restraint Hardware
• When the Tipping Restraint Hardware (RR) is
properly installed, it can provide protection
against unexpected tipping of the Unit due to small
tremors, bumps or climbing.
• Each Tipping Restraint Hardware (RR) includes one
Unit Anchor, one Wall Anchor, one Anchor Tether,
and four Anchor Screws. Use these to complete the
following steps for a proper installation.
• Locate a secure wall stud behind the unit closest to
left side.
• Align the Unit Anchor with a wall stud and attach
to the Unit with two Anchor Screws using a Philips
Screwdriver. The Anchor Screws must pass through
the Top Assembly for proper installation.
• Align the Wall Anchor in the center of the wall stud,
at level with the Unit Anchor, and with two Anchor
Screws using a Philips Screwdriver.
• On the Anchor Tether, detach the cable from the
connector and loop the loose cable through the
eyelets on the Wall Anchor and Unit Anchor.
Reattach the loose cable to the connector, but do not tighten.
• Locate a secure wall stud behind the unit closest to the right side and repeat the steps above.
• Tighten both Anchor Tethers by pulling the cable the through connector.
NOTE: Installation of the Tipping Restraint Hardware (RR) will provide a small space between the
wall and the unit. This will allow you to run power cords and connector cables to your
television or other devices placed on top of the unit.
WARNING: Installing the Tipping Restraint Hardware will help prevent accidents or damage to the
unit.
Hardware Used
Tipping Restraint
RR
Hardware
28WM373 REV2.0
x1
23
40
Publicidad
