Publicidad
Idiomas disponibles
Idiomas disponibles
Always keep the device clean. Use a brush or cloth for cleaning, but do not use any cleaning agents or
solvents.
After mowing, remove any plant remains that have become stuck to the wheels, ventilation opening,
ejector opening and blade area using a piece of wood or plastic. Do not use any hard or sharp objects
as these could damage the device.
Check the device before each use for obvious defects such as loose, worn or damaged parts. Ensure
that all nuts, bolts and screws are firmly in place.
Check the covers and protective devices for damage and correct fit. Replace these if necessary.
REPLACING BLADES
If the blade is blunt, it can be re-sharpened by a specialist company. If the blade is damaged or unbalanced,
it must be replaced.
1) Turn the machine over.
2) Use firm gloves and keep hold of the blade (20). Use a spanner to turn the blade bolt (21)
counter-clockwise from the motor spindle (22).
3) Reassemble the new blade (20) in reverse order. Make sure that the blade(20) is positioned correctly
and that the blade bolt (21) is tightened.
TROUBLE SHOOTING
The following chart lists problem symptoms, possible causes and corrective action, if your machine does
not operate properly. If these do not identify and correct the problem, contact your service agent.
WARNING: Switch off and remove the isolator key before investigating fault.
Problem
The machine does
not work
Machine
start,
immediately stop
Machine functions
intermittently
Possible Cause
Possible clogging
Battery not fully charged
Battery not inserted (properly)
Grass too long
Isolator damage
Motor protector has activated
Battery too hot/cold
Isolator
key
not
correctly/fully
There is a short delay in the
motor starting after engaging
the switch lever
Battery not fully charged
Isolator
key
not
correctly/fully
Battery not inserted (properly)
Battery too hot/cold
Internal wiring of machine
damaged
Motor protector has activated
Corrective Action
Check underneath the machine and clear out
as necessary (always wear gardening gloves)
Battery Charging
Inserting the Battery
Increase height of cut and tilt machine to
reduce starting load
Contact Service Agent
Allow motor to cool /increase height of cut
Allow to cool/warm
inserted
Fit correctly
Hand switch lever for 1–3 s to start motor
Battery Charging
inserted
Fit correctly
Inserting the Battery
Allow to cool/ Increase height of cut
Contact Service Agent
Allow motor to cool /increase height of cut
96
EN
Publicidad
