Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING THE AXDIS-TY1
For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED
• Start the vehicle.
• Connect the AXDIS-TY1 harness to the wiring harness in the vehicle.
• The LED will initially turn on solid Green, then turn off for a few seconds while it auto
detects the radio installed.
• The LED will then flash Red up to (23) times indicating which radio is connected to the interface,
and then turn off for a couple of seconds. Pay close attention to how many Red flashes there
are. This will help in troubleshooting, if need be. Refer to the LED feedback section for more
information.
• After a couple seconds the LED will turn on solid Red while the interface auto detects the
vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
• Once the vehicle has been auto detected by the interface, the LED will turn on solid
Green, and the radio will come back on, indicating programming was successful.
• Test all functions of the installation for proper operation, before reassembling the dash.
If the interface fails to function, refer to Resetting the AXDIS-TY1.
Note: The LED will turn on solid Green for a moment, and then turn off under normal
operation after the key has been cycled.
6
AUDIO LEVEL ADJUSTMENT
(amplified models only)
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counter clockwise to lower the audio level.
3. Once at a desired level, audio adjustment is complete.
Publicidad
