Silvercrest SSRM 10 A1 Manual De Instrucciones página 53

SNOOZE function
 To pause the alarm tone for approx. 5 minutes, briefly press
the "MODE" button (3) during the signal tone. During these 5
minutes, the corresponding alarm symbol (12,13) flashes on
the display (1) and the "SNOOZE" symbol (15) is indicated.
 After approx. 5 minutes, the alarm tone starts again. To switch
off the alarm tone, briefly press the "On/Standby" button (6).
Storage when not in use
If you will not be using the scan radio for an
extended period of time, remove the batteries to
avoid leakage.
Store the clean device in a dry, cool location.
Troubleshooting
No sound / no reception
 Check whether the earphones (B) are inserted correctly into
the earphone jack (8).
 Check whether the volume is set too low.
 Change your location to check whether the reception
improves.
 Check the capacity of the batteries (C), and replace them if
necessary with new batteries of the same type. Please pay
particular attention to the section "Inserting the batteries".
SilverCrest SSRM 10 A1
English - 51