Publicidad
Idiomas disponibles
Idiomas disponibles
Direction of the switch viewed from be-
hind.
• Left Clockwise direction ⭮
• Centre ὑ Switch lock
• Right Anticlockwise direction ⭯
• On/Off switch (7)
• After inserting the battery: Connect-
ing to the PARKSIDE app
• Switching on: Press
• Switching off: Release
• "Connected" indicator (10)
Status of the connection with the
PARKSIDE app
flashing connection attempt
continuous light connection estab-
lished
• Function selection switch (6)
Turn the function selector switch (6)
so that the desired symbol clicks into
place at the arrow mark.
NOTICE! Risk of damage! Only op-
erate the function selector switch
when the tool has stopped.
Function
Symbol
Drilling (Striking
mechanism OFF)
Hammer drilling
(Percussion ON)
Chisel position ad-
justment
Chiselling
Attaching and removing the
attachment tool
Notes
• Tool holder (1): SDS-Plus
• The attachment tool exhibits some radi-
al play for technical reasons. This has
no effect on the accuracy of the hole.
• Before working, clean the attachment
tool with SDS holder and grease the in-
sertion end slightly with the grease (21)
included in the scope of delivery (0.5 -
1 g).
• Ensure the dust cap (2) is not damaged
when inserting tools. The dust cap (2)
largely prevents drilling dust from enter-
ing the tool holder during operation.
NOTICE! A damaged dust cap (2)
must be replaced immediately. It is re-
commended to have this done by a ser-
vice centre.
• Directional data viewed from behind.
Attaching the attachment tool
(Fig. B)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
2. Insert the insert tool into the SDS-Plus
tool holder (1) by turning it.
3. Clamp the attachment tool: Release the
locking sleeve (3).
4. Check that the attachment tool is firmly
secure by pulling on it.
Removing the attachment tool
(Fig. B)
1. Unlock the SDS-Plus tool holder (1):
Pull the locking sleeve (3) backwards.
CAUTION! Risk of burn injury!
2.
Attachment tools – especially drills –
can become very hot. Wear protective
gloves whenever appropriate.
Remove the attachment tool.
Adjusting the auxiliary
handle
Notes
• The auxiliary handle (20) can be ro-
tated 360° on the device and can be
moved to any desired/necessary posi-
tion.
• Directional data viewed from behind.
GB
MT
33
Publicidad
