Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for use
EN
1. Insert the main holder into the main body, and tight up by the nut (10).
2. Insert the 5pcs wheels (20) into the weight rubber (19) , and tighten up by the screws (21)
and the gasket (22).
3. Put the back grill (5) on the motor shaft, and tighten up by the grill lock nut (7) to the motor
cover (8) . Insert the blades(4) on the motor shaft, and tighten up by the blade lock nut (3).
4. Fixed the misting board (1) on the front grill (2), and tight up by misting board lock screws.
5. Connection the front grill (2) and back grill (5) by grill ring (6), and tighten up by grill lock
nut.
Fill the water tank:
Unscrew the valve cover to open the tank turning it anticlockwise, fill the tank with cold and
clean water making sure not to overfill it. To close the tank, screw the valve cover back on
securely turning it clockwise. Turn the tank over and place it back into its designated space
at the back of the fan main body.
Loosen
Tighten
ATTENTION!
• Make sure the product is unplugged from the mains before filling or refilling the water tank.
• Only use water in the water tank. Do not add any chemicals, oils or other additives.
• Only use cold or lukewarm water in the water tank. The water must not be warmer than
40° C.
Control panel
Remote Control
6
Publicidad
