Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Attaching the clippings collector
1. First slide the clippings collector (14)
with the angled edge onto the safety
cutter bar (2).
Removing the clippings collector
1. Pull the clippings collector (14) for-
wards off the safety cutter bar (2).
Checking the battery charge
level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (11) next to the
charge level indicator button (12) on
the battery (9).
The LEDs of the charge level indicator
show how much charge remains in the
battery.
2. Charge the battery (9) when only the
red LED on the charge level indicator
(12) is illuminated.
Charging the battery
See also the charger instruction manual.
Notes
• If warm, allow the battery to cool be-
fore charging.
• Do not expose the battery to direct sun-
light for long periods and do not place
it on a radiator (max. 50°C).
Charging the battery
1. Remove the battery (9) from the
device.
2. Push the battery (9) into the charging
slot of the battery charger (15).
3. Connect the battery charger (15) to a
power outlet.
4. After charging, disconnect the battery
charger (15) from the mains.
36
Meaning
Battery partially
charged
Battery needs to be
charged
5. Pull the battery (9) out of the battery
charger (15).
Control LEDs on the charger (15):
green
red
lights up
—
—
lights up
—
flashes
flashes
flashes
Operation
Working with the device
WARNING! Risk of injury! Pay atten-
tion to the following instructions.
• NOTICE! Damage to the safety cutter
bar (2). While cutting, make sure that
you do not touch any objects, such as
wire fences or plant supports.
• Always wear sturdy shoes, long
trousers, ear protection, work gloves
and protective goggles when operating
the device.
• The device is only intended for work
where you are standing on the ground
and not on a ladder or other unstable
surface.
• Do not use the device if a switch is
damaged.
• If the safety cutter bar (2) becomes
jammed with solid objects, switch the
device off immediately and remove the
batteries. Only then should you remove
the object.
• Avoid over-stressing the device while
working.
Cutting techniques
• Cut out thick branches in advance us-
ing lopping shears.
Meaning
• Battery is fully
charged
• stand-by (No
battery inserted)
Battery is charging
Battery is over-
heated
Battery is defective
Publicidad
