Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Setting the stroke rate
Procedure
• Press the stroke rate button (19) to set
the corresponding stroke rate.
The relationship between the number 1
2 3 on the display (level) (20), the stroke
rate per minute and the cutting movements
per minute is shown in the following table.
level
1
Stroke
1000
rate
-1
min
Cutting
2000
move-
-1
min
ments
Switching on and off
Notes
• The device may only be used with two
batteries.
• Remove the encasing (13) from the
safety cutter bar (2) before switching
on the device.
• The on/off switch (7) and the safety
switch (21) must not be locked. The
motor must be switched off when the
switch has been released.
Switching on
CAUTION! Personal injury or dam-
age to the device! Ensure your stance is
stable and hold the device tightly with
both hands and away from your body.
1. Remove the encasing (13).
2. Make sure that the batteries (9) are in-
serted.
3. Always hold the device with both
hands: One hand on the handle (8)
and the other hand on the front handle
(4).
4. Press the safety switch (21) on the front
handle (4).
38
2
3
1500
1800
-1
-1
min
min
3000
3600
-1
-1
min
min
5. NOTICE! Before switching the device
on, make sure that it is not touching
any objects.
Press and hold the safety switch (21)
on the front handle (4) while pressing
the On/Off switch (7) on the handle
(8).
The device runs at the lowest speed.
For setting the speed, refer to the
section "Setting the stroke rate,
p. 38".
Switching off
1. Release one of the two switches.
2. Wait until the power tool has stopped
before placing it down.
3. Remove the rechargeable battery (9)
from the device if you are leaving the
device unattended or if you have fin-
ished working.
Checking the charge status
of the battery in the device
1. Press the button for the charge level in-
dicator (18) on the operational control
(5).
The charge level of the battery is indic-
ated by illumination of the correspond-
ing LEDs on the charge level indicator
(17).
During operation, the charge level of
the battery is permanently displayed
on the charge level indicator on the
device (17).
Red amber and green ⭢ battery
fully charged
Red and amber ⭢ battery approx.
half charged
Red ⭢ battery needs to be charged
2. Charge the battery (9) when only the
red LED on the charge level indicator
on the device (17) is illuminated.
Publicidad
