TOPDON ArtiDiag Serie Manual Del Usuario página 26

4.5 Maintenance
For ArtiDiag500: This function provides you with 6 maintenance
services including Oil Reset, Throttle Adaptation, EPB Reset,
Steering Angle Reset, BMS Reset and TPMS Reset.
For ArtiDiag600: This function provides you with 8 maintenance
services including Oil Reset, Throttle Adaptation, EPB Reset,
Steering Angle Reset, BMS Reset, TPMS Reset, DPF Regeneration
and Injector Coding.
4.5.1 Services Overview
Oil Reset
This function allows you to reset the oil service lamp for the engine
oil life system. The engine oil light system calculates an optimal oil
change interval depending on the vehicle's driving conditions and
weather events. Oil resets are required every time the engine oil is
changed.
Throttle Adaptation
If the ECU is disconnected accidentally, or if the throttle is replaced
or cleaned, then the throttle actuators need to be initialized via the
Throttle Adaptation function. This resets the ECU's data to its initial
state so that the throttle can accurately regulate the air intake.
EPB Reset
This function helps you replace and reset the brake pads.
It needs to be performed in the following cases:
· After the brake pads and brake pad wear sensors are replaced.
· When the brake pad warning light is on.
· After a short circuit in the brake pad sensor is fixed.
· After the servo motor is replaced.
Steering Angle Reset
If the steering angle sensor is replaced, or the steering angle is
inaccurate or not centered, the steering angle reset function needs
to be performed to find the relative zero position. With this position
as a reference, the ECU can then calculate the exact angle for left
and right steering.
BMS Reset
After the car battery is replaced, the car battery control unit needs
to be reset. This will clear fault information (such as low battery
level) so that the control unit can match the relevant information of
the newly replaced battery.
23