Publicidad
Idiomas disponibles
Idiomas disponibles
assembly, startup, operation, maintenance and setting up of the machine, independent structural
alterations or settings on the machine beyond the intended purpose.
• Inadequate supervision of wear parts.
• Improperly carried out repairs, inspections or maintenance.
• Catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our control.
General
The disassembly and re-assembly is done only according to the technical drawing. Observe the safety
instructions of the operation and maintenance manual. In case of damages, our service is at your
disposal.
Disassembly
All parts are coordinated in a way that they can be dismantled by light pushing or knocking (wooden base /
rubber hammer).
Motor
Clamp the machine at the gearbox housing item 40 into the vice. Use plastic jaws that enclose the gearbox
housing as far as possible and unscrew the housing, assy. item 1.
Then pull out the motor. Open the motor on the toothed side for changing the vanes item 8, the front end
plate item 9, the cylinder bushing item 5 or the grooved ball bearings items 3 and 11.
This will be done by holding the motor at the cylinder bushing and knocking the toothed side of the rotor
item 7 against a wooden base. During installation of new vanes take care that the vanes do not jut out of
the rotor.
Gear
Attention! The planetary gear can be completely removed from the gearbox housing. Lever up the three-
jaw chuck item 100 with the help of two levers (or special tool) from the planet carrier output shaft. Lightly
knock the edge of the gearbox housing (on the thread) on a wooden base. The gearbox comes off and can
be drawn out of the housing easily. Grease the gearbox at re-assembly.
Connection of handle
Screw out connecting nipple item 78 and sound absorber item 82. Loosen screws item 76 and take off the
air and silencer connection item 75 as well as the spacer ring item 71. Pull the guide sleeve item 70 out of
the seat.
Assembly hint
Repairs should be executed by authorized professionals only and with assistance of the sectional drawing.
Re-assembly
Re-assemble after checking and replacing worn parts. It will be done essentially in the reverse order than
the disassembly. Lightly grease all parts to avoid falling apart during re-assembly. Remove any oil and
resin residue from the rotor slots. The vanes should fit easily into the rotor slots.
REPAIR AND SPARE PARTS LIST
REPAIR
37
Publicidad
